Specification
| Operating voltage | 10-30Vdc polarity protection, 5Vdc optional |
| Current consumption | <35mA (24Vdc) no-load |
| Output signal | SSI synchronous serial signal, Gray code(default), binary code optional |
| Signal transmission | Two pairs of RS422, 100 meters (125KHz and recommend special cables, more distance please consult factory) |
| Linear Resolution | 1/8192FS, 1/16384FS |
| Repeatability | Repeatability ± 2BIT (actual accuracy relate to precision of installation and the shaft concentricity ) |
| Clock frequency | The fastest clock frequency can be set 500KHz, recommend 125KHz. |
| Working temperature | -40 ~ 80 ℃ |
| Storage temperature | -40 ~ 80 ℃ |
| Protection class | Shell IP67, IP65 shaft |
| Vibration and shock | 10g, 10 ~ 2000Hz; 100g, 6ms |
| Allowed speed | 2400 rev / min |
| Connection cable | 1 m shielded cable radial side (rest form can be ordered) |
| Shape characteristics | Metal shell, sealed double bearing |
SSI protocol description:
SSI is a synchronous serial signal, two pairs of RS422, one pair of clock trigger, a pair of data transmission.
As shown, the absolute position value of the encoder is triggered by clock signal of the receiving device, from the high bit of Gray code(MSB),output serial signal synchronized with clock signal. The clock signal sent from the receiving device, refer to the total number bits of the encoder, output N interrupt pulse. When the signal is not transmitted, the clock and data bits are high, at the first falling edge of the clock signal, storing the current value, from the rising edge of the clock signal, sending data signal, A clock pulse synchronization a data.
Wherein: t3 is the restore signal, waiting for the next transmission; N = 13; 16; 25; 28. (Total number of digits according to the encoder)
T = 4-11us; t1 = 1-5.5us; t2 ≤ 1us; t3 = 11-15.5us (Clock-and Date-omit not shown).
In actual use, in order to ensure the stability of the signal with the transmission distance farther, recommended the following parameters:
T = 8us (125KHz); t1 = 4us; t2 (the actual reading latency = 3 ~ 4us); t3 = 15us
Data processing
Encoder output is Gray cyclic code, first, receiving device decode it into binary code by XOR way. AS Gray code is cyclic code, there are mutations between maximum code value and 0, therefore, in order to avoid abrupt stroke data, recommended the middle of encoder position data value as the start bit. When the encoder is installed, turn it to the starting position of the actual work. When installed, turn the encoder to the start position in the actual work, take MIDP core wire short contact to power +, and the current signal is the middle of encoder position data value, then take MIDP wire back to power 0. After the current measured values received into binary code, it should be handled as follows:
The actual position value = (C-MidP) × Dir + starting position value
The above formula, C is the encoder output current measured values; MidP is the middle position value , 2n-1, 13 bits is 4096, 16 bits is 32768, 25 bits is 2048 × 8192; 28 bits is 2048 × 65536 . DIR is the direction of rotation of the encoder coefficients, if same to the direction of calculation, defined 1; if opposite, defined -1.
The starting point is not necessarily zero, calibrated by the user to determine their own position, due to multi-turn encoder can have 4096 Circle of continuous measurement, from the start point, both forward and reverse loop continuously working stroke 2048.
Installation dimensions (mm)
Clamping flange (default)
synchro flange
Blind hollow shaft
